Published at Wednesday, July 31st 2019. by Loring Francoeur in Garage.
Pegboard storage ideas are one of the cheapest ways to go as far as the cost of the pegboard itself, as well as the accessories for them. A full wall section can cost as low as $10 dollars for a four by four section, depending on the kind of materials used. You can effectively do your whole wall for under $200, if you want to go with the wood press board.
The market has now met the demand for diversity and customization that wall storage consumers have been demanding in the past, the standard white hardboard pegboard is obsolete and costwize only a little cheaper than it’s new modern metal counterpart which is almost endless in the ways it can be customized by the consumer and has many varieties of design, color and utility that would meet any and all detailed requirements of a buyer. This is custom colored pegboard and is made from metal, it is durable and will outlast the traditional hard board peg board by many decades. Designed with utility in mind these metal pegboard panels have both round peg board holes and thin vertical slots placed side by side on the metal wall panels in rows.
Common faults with fibre board panels were the fixtures often popped off when you removed tools, an annoying habit that is remedied today with metal wall panels that require a special movement to unfix a fixture, ensuring the fixtures stay put when you remove a tool. A metal striped pegboard panel will not be damaged by moisture or water damage and will not warp under extreme temperature and physical conditions. A metal striped pegboard panel will not chip or sag from the weight of the tools it supports, there is also the danger of the fine fibre particles themselves from the pegboard which can enter the lungs and cause much damage to your health.
Quality: You can get custom storage systems on just about any budget. It all depends on the materials and the size of the overall system. It is not a quick process, and it can take several days for the manufacturer to complete and install each piece. Despite the fact that you may have to wait, what you get in return is quality you cannot find in a big box store. Some establishments market these systems as garage cabinets. However, it is better to use these materials in home closets. The design is not for the daily climates found in most garages. They easily wear out, and replacement is necessary within just a few months to a few years. Storage systems designed for your space use tougher material and seal it with a powder coat that makes it resistant to UV light, dents, scratches, and stains. The design lasts for years, even when you use it daily.
There is just no limit to the accessories you can buy, and many of these are priced well below ten dollars. This is one of the biggest advantages of using pegboards to organize you garage. You just need to secure them to the studs in your wall, and have a little bit of space between the wall and the board to allow the hook part to extend to the backside of the board.
Anyway, I’ve learned that working on cars is a whole lot easier if my garage is as clean and organized as possible. That’s why I’ve got pegboards all along each wall, several toolboxes, and a bunch of oil absorbent pads right at my side. I’ve gotten in the habit of hanging my tools neatly on the pegboards or placing them in a toolbox as soon as I’m done using them. This cuts down on wasted time because I no longer have to spend five minutes looking for a particular wrench. I know exactly where it is at all times.
Light Switch: Another way to modernize your garage is to upgrade the light switch with one that’s illuminated when the lights are off. This eliminates fumbling around looking for the switch while leaning over, and holding the entry door open for enough light to find the switch. Even better, it’s inexpensive and easy to do yourself. With basic knowledge of electricity, all you have to do is turn off the breaker that feeds the switch and wire up the new switch the same way. There are no additional wires to worry about. The end result is a mild orange glow that’s easy to find in the dark. Another option is to add motion sensors to your garage lights so they come on as soon as you open the door. You can even get motion bases that screw into standard sockets. Once installed, all you have to do is screw in the light bulb as usual. This is a clever way to have motion activated lighting without having to do any wiring.
Any content, trademark’s, or other material that might be found on the Beauty-paradiese website that is not Beauty-paradiese’s property remains the copyright of its respective owner/s. In no way does Beauty-paradiese claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Beauty-paradiese. All Rights Reserved.